Download

Table 2. Orbi add-on satellite LED description
LED BehaviorLED
The Power LED is located above the Power On/Off button on the rear panel. Note: The wall plug
satellite does not include a Power LED.
• Solid green. Power is on.
• Solid amber. The satellite is rebooting.
• Blinking amber. The satellite is resetting to factory default settings.
• Blinking red. The firmware is corrupted.
• Off. Power is not supplied.
Power LED
Optional add-on satellites are sold separately and can be added to your Orbi network. The ring
LED is located on the top.
• Pulsing white. The satellite is booting.
• Solid white. The satellite is ready to sync to the router (press the Sync button).
• Blue for three minutes. The connection between the satellite and the router is good.
• Amber for three minutes. The connection between the satellite and the router is fair.
• Magenta. The satellite is not connected to the router or is not getting an IP address.
• Off. The satellite synced to the router and is working normally.
Add-on satellite ring
LED
Connect Your Router
To cable your router:
1. Unplug your modem’s power, leaving the modem connected to the wall jack for your Internet service.
If your modem uses a battery backup, remove the battery.
2. Plug in and turn on your modem.
If your modem uses a battery backup, put the battery back in.
Overview
19
Orbi WiFi System