Installation Guide

NMS300 Network Management System Application
Discover Resources Quick Start Guide38
Note: If you are setting up a Telnet device credential for a managed switch
for which the privileged EXEC password was changed (on the Enable
Password Configuration page of the switch local browser UI), enter the
privileged EXEC password in the Enable Password field. The Enable
Password field displays when you select Telnet from the Protocol
menu.
Note: For an M4250 series fully managed switch, if you select the SNMP V3
from the Protocol menu, SHA512 is the only authentication option in
the Authen Protocol menu, and AES128 is the only encryption option
in the Privacy Protocol menu. (Both of these selections are required
for the SNMPv3 protocol.)
9. Click the Management Interface tab.
10. Enter the port number, time-out period in seconds, and the number of retries.