Owner's Manual

File Server / File Management
176
ProSafe Network Management Software NMS200
Add Schedule opens the scheduling screen to let you automate the backup you have
configured on a specified date, time, or repetition. See Schedule Actions o
n page 169.
Execute p
erforms the backup immediately. The Results tab in this screen opens,
displaying the message traffic between NMS200 and the device(s). See Audit Trail Portlet
on page 52.
Save prese
rves this configuration without scheduling or executing it.
Close closes this screen
without saving the configured backup.
Deploy Configuration
When you deploy a configuration, a screen appears to configure how that occurs.
It has the following fields:
Select Firmware Image
• Firmware Im
age — The identifier for the image
• Desc
ription — The description for the image
• Ve
rsion — The version for the image
• Generate and Save Configurati
on Only — Check this if you simply want to configure for
later restoration.
• La
bel for Configuration — Enter a label name, if applicable.
Select Targets for Deployment
Use the Add Equipment or Add Groups buttons to select individual devices or groups of
devices (both are possible together). Use Remove All to delete all targets, or use the delete
icon in the Action column to delete individual equipment or groups.
Note: The listed targets must still pass the filter set in the editor’s General
Parameters.
Restore a single configuration to many target devices
The following steps describe restoring a single config
uration to many discovered devices
without overwriting those devices’ essential information.
1. Back up
a single device’s configuration that is nearest to the kind you would like to see
generally.
2. Right-click
this backed up file in the File Management portlet, and Promote it so it appears
in the Image Repository portlet.
3. Right-click > Edit
the promoted configuration in the Image Repository.