ProSafe Network Management System Reference Manual
Table Of Contents
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Startup
- Chapter 3 Data and Statistics
- Chapter 4 Polling and Emailing
- Chapter 5 Troubleshooting and Advanced Configuration
- Troubleshooting Network Discovery
- Duration of Network Discovery
- Normal Discovery Map Layout
- Failure Symptoms and Solutions
- Discovery Agent Fails to Connect to the Server
- Incorrect or Missing Community Names
- SNMP Device Access Control List
- Firewalls Block SNMP Operations
- Not Enough Seeds
- Broadcast Packet Losses
- Limiting the Scope of Discovery
- Setting Up New Filters
- Stopping Discovery Auto-Layout
- Troubleshooting Network Discovery
- Appendix A
- Glossary
- Index
A-1
September 2004 202-10036-01
Appendix A
Event Parameters
Use Event Parameters in Event Action Filters to substitute information related to a specific event.
Event Parameters can be used in the Event Message and as arguments to a program in the Exec
Program action. The available Event Parameters and the associated expansion are described in the
following table.
Table 5-1. Event Parameters
Event
Parameters
Description
$$ The dollar ($) symbol
$V Event message text (for Exec Program action).
$W Console frame window number.
$M Server IP Address.
$R Address of sending entity (could be the same as the target device, or it could be
a Polling Agent address).
$F Event Action Filter name.
$f Event Action Filter database record number.
$O Trap Name as a textual string.
$o Trap Object Identifier in dot format.
$A Address of target device (device that the event is about)
$T Trap Community Name.
$x Date the event occurred, in local format at server.
$X Time the event occurred, in time zone of server.
$@ Time the event occurred, in seconds since Jan 1, 1970.
$U Value of sysUpTime in the event trap.
$N The map object name of the target device.
$i The map database record number of the target device.
$G The Read Community name of the target device