ProSafe Network Management System Reference Manual
Table Of Contents
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Startup
- Chapter 3 Data and Statistics
- Chapter 4 Polling and Emailing
- Chapter 5 Troubleshooting and Advanced Configuration
- Troubleshooting Network Discovery
- Duration of Network Discovery
- Normal Discovery Map Layout
- Failure Symptoms and Solutions
- Discovery Agent Fails to Connect to the Server
- Incorrect or Missing Community Names
- SNMP Device Access Control List
- Firewalls Block SNMP Operations
- Not Enough Seeds
- Broadcast Packet Losses
- Limiting the Scope of Discovery
- Setting Up New Filters
- Stopping Discovery Auto-Layout
- Troubleshooting Network Discovery
- Appendix A
- Glossary
- Index
Reference Manual for the ProSafe Network Management System NMS100
4-12 Polling and Emailing
September 2004 202-10058-01
3. Then, add an Event Filter for the selected devices
a. Add a new event filter for a set of devices as described in Steps 4 through 7 of “Emailing
or Paging the Administrator on an Event” on page 5-6.
b. In the Action tab, select SwitchOperators in the Page pull-down to page the two new users.
c. Select SwitchOperators in the Email pull-down to send email to the two new users.
d. In the Match tab of the Add Event Filter dialog, make sure that you match different
devices than those used in the previous section (emailing the Administrator). Otherwise,
this new filter will not be unique and it will not match any incoming events.
e. Remember to set the Auto-Clears flags for any matching events.