ProSafe Network Management System Reference Manual
Table Of Contents
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Startup
- Chapter 3 Data and Statistics
- Chapter 4 Polling and Emailing
- Chapter 5 Troubleshooting and Advanced Configuration
- Troubleshooting Network Discovery
- Duration of Network Discovery
- Normal Discovery Map Layout
- Failure Symptoms and Solutions
- Discovery Agent Fails to Connect to the Server
- Incorrect or Missing Community Names
- SNMP Device Access Control List
- Firewalls Block SNMP Operations
- Not Enough Seeds
- Broadcast Packet Losses
- Limiting the Scope of Discovery
- Setting Up New Filters
- Stopping Discovery Auto-Layout
- Troubleshooting Network Discovery
- Appendix A
- Glossary
- Index
Reference Manual for the ProSafe Network Management System NMS100
Polling and Emailing 4-7
September 2004 202-10058-01
2. Then, set the Email/Paging global event options
a. Use the Config/Event Options menu.
b. Set the SMTP Server Address to the IP Address of your
email server in dot notation (a.b.c.d).
c. Set the Email From Address to an email address that is
valid at your server (such as nms-support@netgear.com).
d. Select the Pager Application (Air Messenger Pro or
Notify!Connect).
e. Select the Enable Tracing to History Log check box. Later,
when you have verified that email works you can disable
this option.
3. Next, set the Administrator Contact Information
a. Use the Config/User Profiles menu.
b. Select the Administrator user and click Modify.
c. Set your email address in the E-mail edit box.
d. Select the Pager Type (numeric or alphanumeric).
e. Set the days and times you want to be emailed and
paged.
f. You can use the Group1 and Group2 edit boxes to
set two alias names for multiple users. For now,
leave Group1 set to Default.