ProSafe Network Management System Reference Manual
Table Of Contents
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Startup
- Chapter 3 Data and Statistics
- Chapter 4 Polling and Emailing
- Chapter 5 Troubleshooting and Advanced Configuration
- Troubleshooting Network Discovery
- Duration of Network Discovery
- Normal Discovery Map Layout
- Failure Symptoms and Solutions
- Discovery Agent Fails to Connect to the Server
- Incorrect or Missing Community Names
- SNMP Device Access Control List
- Firewalls Block SNMP Operations
- Not Enough Seeds
- Broadcast Packet Losses
- Limiting the Scope of Discovery
- Setting Up New Filters
- Stopping Discovery Auto-Layout
- Troubleshooting Network Discovery
- Appendix A
- Glossary
- Index
Reference Manual for the ProSafe Network Management System NMS100
4-4 Polling and Emailing
September 2004 202-10058-01
Polling TCP Application Services
ProSafe NMS supports customized polling of any TCP application service and simplified polling
of four built-in TCP application services (FTP, SMTP, Web, and Telnet).
Discovery of Four Built-in Services
ProSafe NMS polling agents can automatically
check for the existence of the built-in TCP
services on discovered devices and configures
these services to be polled.
Use the Proto tab of the Config/Discovery-
Polling dialog to enable discovery of the four
built-in services.
TCP Service Polling
1. To enable TCP service polling for a device, right-
click the device object in a Map view and use the
Properties menu then select the Attributes tab.
Select the TCP Services attribute.
2. Use the Value pulldown list to select one of the
available TCP services (*Ftp, *Telnet, *Smtp,
*Web and custom names).
3. To select multiple services for the device, type in
the service names in the Value edit box, separated
by commas. For example: “*Ftp,*Web”.
4. Alternatively, double-click the TCP Services
attribute, or use the “>>” button, to select multiple
services.