User manual

Factory Settings and Technical Specifications
68
N300 WiFi Range Extender WN2000RPT
Factory Default Settings
To reset the extender to factory default settings, you can use either the Restore Factory
Settings button on the rear panel or the Erase function. For more information, see Return the
Extender to Its Factory Default Settings on page 55.
The following table lists the factory default settings.
Table 2. Factory default settings
Factory Settings
Setup Wizard Enabled
WiFi WiFi communication Enabled
WiFi network name (SSID) NETGEAR_EXT
Security Disabled
Transmission speed Auto
1
1. Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and environmental factors,
including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput
rate.
Country/region Varies by region
Operating mode 802.11n, 802.11g, 802.11b
Data rate Up to 300 Mbps
DHCP Client enabled