User Manual
Table Of Contents
- Contents
- 1. Hardware
- 2. Install and Access the Switch in Your Network
- 3. Optimize the Switch Performance
- 4. Use VLANS for Traffic Segmentation
- 5. Manage the Switch in Your Network
- 6. Maintain and Monitor the Switch
- Update the firmware on the switch
- Manage the configuration file
- Return the switch to its factory default settings
- Control access to the device UI
- HTTP and HTTPS management access
- Change or lift access restrictions to the switch
- Manage the DoS prevention mode
- Manage the power saving mode
- Control the port LEDs
- Change the switch device name
- View system information
- Date and time settings
- View switch connections
- View the status of a port
- Power over Ethernet
- 7. Diagnostics and Troubleshooting
- 8. Factory Default Settings and Technical Specifications
- A. Additional Switch Discovery and Access Information
Chapter 4 Use VLANS for Traffic Segmentation
VLAN overview....................................................................................33
Activate the Basic Port-Based VLAN mode and assign VLANs.....34
Manage advanced port-based VLANs.............................................35
Activate the Advanced Port-Based VLAN Mode........................35
Create an advanced port-based VLAN.......................................36
Change an advanced port-based VLAN.....................................37
Delete an advanced port-based VLAN.......................................39
Manage basic 802.1Q VLANs...........................................................39
Activate the Basic 802.1Q VLAN mode.......................................40
Create a basic 802.1Q VLAN and assign ports as members....41
Assign the port mode in a basic 802.1Q VLAN configuration..42
Change a basic 802.1Q VLAN......................................................44
Delete a basic 802.1Q VLAN........................................................45
Manage advanced 802.1Q VLANs...................................................45
Activate the advanced 802.1Q VLAN mode..............................46
Create an advanced 802.1Q VLAN.............................................47
Change an advanced 802.1Q VLAN...........................................48
Specify a port PVID for an advanced 802.1Q VLAN..................50
Set an existing advanced 802.1Q VLAN as the voice VLAN and
adjust the CoS value......................................................................51
Change the OUI table for the voice VLAN..................................52
Delete an advanced 802.1Q VLAN..............................................53
Deactivate a port-based or 802.1Q VLAN mode and delete all
VLANs...................................................................................................54
Chapter 5 Manage the Switch in Your Network
Manage NETGEAR Switch Discovery Protocol...............................57
Set up link aggregation.....................................................................57
Make a link aggregation connection...........................................58
Set up a static link aggregation group........................................58
Set up a dynamic link aggregation group..................................59
Enable a link aggregation group.................................................61
Manage multicast...............................................................................62
Manage IGMP snooping...............................................................62
Enable a VLAN for IGMP snooping..............................................63
Manage blocking of unknown multicast addresses..................63
Manage IGMPv3 IP header validation.........................................64
Set up a static router port for IGMP snooping...........................65
Change the IP address of the switch................................................66
Reenable the DHCP client of the switch..........................................67
4
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch