User Manual
Table Of Contents
- Contents
- 1. Hardware
- 2. Install and Access the Switch in Your Network
- 3. Optimize the Switch Performance
- 4. Use VLANS for Traffic Segmentation
- 5. Manage the Switch in Your Network
- 6. Maintain and Monitor the Switch
- Update the firmware on the switch
- Manage the configuration file
- Return the switch to its factory default settings
- Control access to the device UI
- HTTP and HTTPS management access
- Change or lift access restrictions to the switch
- Manage the DoS prevention mode
- Manage the power saving mode
- Control the port LEDs
- Change the switch device name
- View system information
- Date and time settings
- View switch connections
- View the status of a port
- Power over Ethernet
- 7. Diagnostics and Troubleshooting
- 8. Factory Default Settings and Technical Specifications
- A. Additional Switch Discovery and Access Information
Table 1. LEDs on the front panel (Continued)
DescriptionLED
Solid green: 2.5 Gbps link on this port.
Blinking green: 2.5 Gbps activity on this port.
Solid yellow: 1000 Mbps or 100 Mbps link on this port.
Blinking yellow: 1000 Mbps or 100 Mbps activity on this port.
Off: No link is detected on this port.
Left port
Solid green: The port is delivering PoE power.
Off: The port is not delivering PoE power.
Solid yellow: A PoE fault occurred.
Right port
Switch label
The switch label on the bottom panel of the switch shows the serial number, MAC
address, and default login information of the switch.
User Manual10Hardware
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch