User Manual
Table Of Contents
- Contents
- 1. Get Started
- 2. Connect to the Mobile Hotspot
- 3. Manage Battery Usage and Charging
- 4. Manage Your Internet Connection
- 5. Control Internet Access
- 6. Specify Mobile Hotspot Network Settings
- 7. Manage Your Mobile Hotspot Network
- View the Network Information
- View Mobile Hotspot Network Status
- View WiFi Details
- View a Network Map
- View Connected Devices
- Update the Mobile Hotspot Firmware
- Change the admin Password
- Manage SMS Messages
- Back Up and Restore the Mobile Router Settings
- Factory Reset
- Reboot the Mobile Hotspot
- Power Off the Mobile Hotspot
- View Details About Your Mobile Router
- 8. Frequently Asked Questions
- Why can’t my device connect to the mobile hotspot?
- Why can’t I access the Internet?
- Why is the signal indicator always low?
- Why is the download or upload speed slow?
- What do I do if I forget my admin login password?
- How do I disconnect from the mobile broadband network?
- The LCD is not lit. How do I know if the mobile hotspot is still powered on?
- How do I find my computer’s IP address?
- How do I find a device’s MAC address?
- Where can I find more information?
- 9. Troubleshooting
- A. Specifications
6. To change the global WiFi settings, adjust the WiFi standby time or the WiFi range.
7. Click the Apply button.
Your settings are saved.
When you change your profile options (including disabling or enabling either WiFi
network), any devices connected to the mobile hotspot are disconnected and might
need to be reconnected.
Configure Always-On WiFi
Always-On Wifi will route all traffic over the Ethernet WAN. If the Ethernet connection
fails, the device automatically switches to LTE.
Note: In order to enable Always-On WiFi, you must disable Data Offloading.
To configure Always-On WiFi:
1.
On the LCD Home Screen, click Always-on Wifi
2.
Click the Off button to change it to On.
Always-On WiFi is enabled.
Enable the Data Saver From a Web Browser
You can implement the Data Saver to connect your Mobile Router to your local WiFi or
Ethernet network to offload traffice and help conserve your AT&T data plan.
To enable Ethernet data offloading:
1. From a computer that is connected to your network, launch a web browser.
2.
Enter http://attwifimanager or http://192.168.1.1.
A login page displays.
3. Enter the administrator login password.
The password is case-sensitive.
The dashboard displays.
4.
Select SETTINGS > Setup > Data Offloading.
The Data Saver page displays.
5. Set the Data Saver select to ON
6. Select the Enable check box.
7.
Select the Ethernet Offloading selection.
By default, Ethernet Offloading is selected.
User Manual53Specify Mobile Hotspot Network
Settings
Nighthawk 5G Mobile Hotspot Pro