User manual

Getting Started Using FirstGear for the Model XM128S ISDN Digital Modem
3-6 Installation
8.
Select the appropriate driver based on the required data rate and B-channel protocol.
For example, select “Netgear XM128, MP-PPP 128K” to connect to most ISPs. You can
use a different driver for each dial-up connection, thus allowing your applications to
automatically set the appropriate protocol.
9.
Click on OK.
10.
Click on OK again.
The installation of your XM128 modem driver is complete. You can now use programs such
as Dial-Up Networking.
Installing and Launching FirstGear
If you are not setting up your Model XM128S modem with a computer running Windows 95, you
must have a terminal program that allows you to send and receive AT commands and responses
from the modem. For further information about manual configuration, refer to Chapter 4,
“Configuration,” in
Reference Guide for the Model XM128 ISDN Digital Modem
.
To configure your Model XM128S modem with a computer running Windows 95, you must install
the NETGEAR FirstGear software that is included on a disk in your package contents.
To install the FirstGear software:
1.
Insert your NETGEAR FirstGear disk into Drive A on your computer.
2.
Select Run.... from the Start menu of Windows 95.
3.
Type A:\Setup.exe, and press [Enter].
The Welcome screen, as illustrated in Figure 3-5
, opens.
XM128S_bk.fm.book Page 6 Friday, March 6, 1998 11:33 AM