User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Quality of Service User Manual481
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select QoS> DiffServ > DiffServ W
izard.
5. Use T
raffic Type to define the DiffServ Class.
Traffic type options are: VOIP, HTTP, FTP, T
elnet, and Every.
6. Ports displays the ports which can be configured to support a DiffServ policy.
The DiffServ policy is added to selected ports.
7. Use Enable Policing to add policing to the DiffServ policy
.
The policing rate to be applied.
8. Specify the Committed Rate:
• When Policing is enabled, the committed rate is applied to the policy and the policing
action is set to conform.
• When Policing is disabled, the committed rate is not applied and the policy is set to
markdscp.
9. Specify the Outbound Priority:
• When Policing is enabled, Outbound Priority defines the type of policing conform
action where: High sets action to markdscp ef, Med sets the action to markdscp af31,
and Low sets the action to send.
• When Policing is disabled, Outbound Priority defines the policy where: High sets the
policy to mark ipdscp ef, Med sets policy to mark ipdscp af31, and Low sets the policy
to mark ipdscp be.
10. Click the Apply button.
Your settings are saved.