User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Switch Security User Manual560
Configure Private Groups
To configure a traffic control private group:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Security > T
raffic Control > Private Group > Private Group Configuration.
5. In the Group Name field, enter the private group name.
The name can be up to 24 bytes of non-blank characters.
6. In the optional Group ID field, specify the private group identifier
.
The range of group ID is 1 to 192.
7. In the Group Mode list, select the mode of private group.
The group mode can be either isolated or community. When in isolated mode, the
member port in the group cannot forward its egress traf
fic to any other members in the
same group. By default, the mode is community mode that each member port can
forward traffic to other members in the same group, but not to members in other groups.
8. Click the Add button.
The private group is created in the switch.
Configure Private Group Membership
To configure private group membership:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.