User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual420
Add Mroute Static Multicast Entries
You can add static multicast route (Mroute) entries to the Mroute table.
To add static multicast entries to the Mroute table:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > Multicast > Mroute Static-Multicast Configuration.
Incoming Interface The incoming interface on which multicast packets for this source/group
arrive.
Outgoing Interfaces The list of outgoing interfaces on which multicast packets for this
source/group are forwarded.
Up Time (hh:mm:ss) The time in seconds since the entry was created.
Expiry Time (hh:mm:ss) The time in seconds before this entry ages out and is removed from the
table.
RPF Neighbor The IP address of the reverse path forwarding (RPF) neighbor.
Protocol The multicast routing protocol which created this entry. The possible
values are as follows:
• PIM-DM
• PIM-SM
• DVMRP
Flags The value displayed in this field is valid if the multicast routing protocol
running is PIM-SM.
The possible values are RPT or SPT. For other
protocols a “------” is displayed.
Table 152. Multicast Mroute Table (continued)
Field Description