Owner's Manual

Advanced Settings
80
N300 Wireless Router JWNR2000v3
- If you are setting up a point-to-point bridge, select the Disable Wireless Client
Association check box.
- If you want all client traf
fic to go through the other access point (repeater with
wireless client association), leave the Disable Wireless Client Association check
box cleared.
• Base Station MAC
Address. If your router is the repeater, enter the MAC address for
the access point that is the base station.
• W
ireless Base Station. If your router is the base station, select this check box.
• Disable W
ireless Client Association. If your router is the base station, selecting this
check box means that wireless clients cannot associate with it. Only LAN client
associations are allowed.
• Repeater MAC
Address (1 through 4). If your router is the base station, it can act as
the “parent” of up to 4 other access points. Enter the MAC addresses of the other
access points in these fields.
3. Click Apply.
Your settings are saved.
Set Up the Base Station
The wireless repeating function works only in hub and spoke mode. The units cannot be
daisy-chained. You must know the wireless settings for both units. You must know the MAC
address of the remote unit. First, set up the base station first, and then set up the repeater.
 To set up the base station:
1. Set up both units with the same wireless settings (SSID, mode, channel, and security).
The wireless security option must be set to None or WEP
.
2. Select ADV
ANCED > Advanced Setup > Wireless Repeating Function.
The Wireless Repeating Function screen displays.