Owner's Manual

Administration
63
N300 Wireless Router JWNR2000v3
• IP Address. The IP address that the Internet (WAN) port of the router uses. If no address
is shown or the address is 0.0.0, the router cannot connect to the Internet.
• Connection.
This shows if the router is using a fixed IP address on the WAN. If the value
is DHCP Client, the router obtains an IP address dynamically from the ISP.
• IP Subnet Mask.
The IP subnet mask that the Internet (WAN) port of the router uses.
• Domain Name Server. The Domain Name Server addresses that the router uses. A
Domain Name Server translates human-language URLs such as www.netgear.com into
IP addresses.
• Show Statistics button. Click the Show Statistics button to display the following
screen:
The Show Statistics screen provides the following information:
• System Up T
ime. The time elapsed since the router was last restarted.
• Port.
The statistics for the WAN (Internet) and LAN (Ethernet) ports. For each port,
the screen displays the following information:
- Status.
The link status of the port.
- TxPkts.
The number of packets transmitted on this port since reset or manual
clear.
- RxPkts.
The number of packets received on this port since reset or manual clear.
- Collisions.
The number of collisions on this port since reset or manual clear.
- Tx B/s.
The current transmission (outbound) bandwidth used on the WAN and
LAN ports.
- Rx B/s.
The current reception (inbound) bandwidth used on the WAN and LAN
ports.
- Up T
ime. The time elapsed since this port acquired the link.
- Poll Interval.
The interval at which the statistics are updated in this screen. To
change the polling frequency, enter a time in seconds in the Poll Interval field, and
click Set Interval. To stop the polling entirely, click Stop.