User Manual

Maintenance
730
M6100, M5300, and M7100 Series Managed Switches
 To configure Dual Image settings:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select Maintenance > File Management > Dual Image Configuration.
8. Use Unit to select the unit ID whose code image to activate, update, or delete.
9. Use Next Active Image to make the selected image the next active image for subsequent
reboots of this unit.
10. Use Image Description to specify the description for the image that you selected.
11. Click the Delete button to delete the selected image from permanent storage on the switch.
12. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Note: After activating an image, you must perform a system reset of the
switch to run the new code.