User Manual

Monitor the System
703
M6100, M5300, and M7100 Series Managed Switches
8. Select the Session ID number from the list.
9. Select the Admin Mode True (enabled) or False (disabled) radio button for the selected
session.
When a particular session is enabled, any traffic entering or leaving the source ports of
the session is copied (mirrored) onto the corresponding destination port or a remote
switched port analyzer (RSPAN) VLAN. By default, Admin mode is False (disabled).
10. Select the RSPAN Destination VLAN from the list of available VLAN IDs.
11. Select the RSPAN Reflector Port from the list of reflector port interfaces.
12. Select from the Filter Type list to configure IP or MAC ACLs that can mirror traffic that
matches a permit rule.
Possible values are as follows:
• None.
• IP ACL. Configure IP ACL.
• MAC ACL. Configure MAC ACL.
13. Enter the Filter Name, if a filter is configured for the session.
14. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
 To configure an RSPAN source interface:
1. Select a Unit ID (1, 2, 3) to display a list of physical ports for the selected unit.
2. Select LAG to display LAGs only.
3. Select CPU to display CPUs only.
4. Select VLAN to display a list of available VLAN IDs.
5. Select All to display all physical ports, LAGs, CPUs, and VLANs.