User Manual

Monitor the System
693
M6100, M5300, and M7100 Series Managed Switches
The Status field displays whether the host was configure to be actively logging or not.
8. Select the Admin Status Disable or Enable radio button.
This enables or disables logging to configured syslog hosts. Setting this to disable stops
logging to all syslog hosts so that no messages are sent to any collectors or relays.
Enable means messages are sent to configured collectors or relays using the values
configured for each collector or relay.
9. Use Local UDP Port to specify the port on the local host from which syslog messages are
sent.
The default port is 514.
10. Specify the Source Interface to use for syslog.
Possible values are as follows:
• None
• Routing interface
• Routing VLAN
• Routing loopback interface
• Tunnel interface
• Service port
By default, VLAN 1 is used as source interface.
11. Use IP Address Type to specify the address type of host.
It can be one of the following:
• IPv4
• IPv6
• DNS
12. iIn the Host Address - This is the address of the host configured for THE syslog.
13. In the Port field, specify the port on the host to which syslog messages are sent.