User Manual

Manage Device Security
672
M6100, M5300, and M7100 Series Managed Switches
8. In the ACL ID menu, select an IP ACL.
Note: Binding ACLs to interface fails when the system has no resources to
bind a new ACL. IPv4 ACLs and IPv6 ACLs cannot be bound at the
same time to an interface.
9. Select the packet filtering Direction for ACL.
Valid directions are Inbound or Outbound. The packet filtering direction for ACL is
Inbound, which means the IP ACL rules are applied to traffic entering the port.
10. Specify an optional Sequence Number to indicate the order of this access list relative to
other access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If you do not specify the sequence number
(meaning that the value is 0), a sequence number that is one greater than the highest
sequence number currently in use for this interface and direction is used. The valid range
is 1–4294967295.
11. The Port Selection Table lists all available valid interfaces for ACL mapping.
All non-routing physical interfaces, and interfaces participating in LAGs, are listed. Click
the appropriate unit name to expose the available ports or LAGs:
• To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that an X appears in the box.
• To remove the selected ACL from a port or LAG, click the box directly below the port
or LAG number to clear the selection. An X in the box indicates that the ACL is
applied to the interface.
12. Click the Apply button to save any changes to the running configuration.