User Manual

Manage Device Security
549
M6100, M5300, and M7100 Series Managed Switches
8. To add a RADIUS server, specify the following settings:
• In the Radius Server IP Address field, specify the IP address of the RADIUS server.
• In the Radius Server Name field, specify the name of the server.
• Use Port to specify the UDP port used by this server. The valid range is 0–65535.
• Secret Configured. The secret is applied only if this option is Yes. If the option is No,
anything entered in the secret field has no effect and is not retained.
• Use Secret to specify the shared secret for this server.
• Use Primary Server to set the selected server as a primary or secondary server.
• Use Message Authenticator to enable or disable the message authenticator attribute
for the selected server.
9. Click the Add button.
The server is added to the switch.
This button is available only when you log in with the admin user name, which has
read-write permission. These changes are not retained across a power cycle unless a
save is performed.
10. To remove the selected server from the configuration, click the Delete button.
This button is available only when you log in with the admin user name, which has
read-write permission. These changes are not retained across a power cycle unless a
save is performed.
The Current field indicates if this server is currently in use as the authentication server.
To reset the authentication server and RADIUS statistics to their default values, click the
Clear Counters button at the bottom of the screen.
The following table describes the RADIUS server statistics displayed on the screen.