User Manual

Configure Quality of Service
536
M6100, M5300, and M7100 Series Managed Switches
• Mark CoS - These packets are marked by DiffServ with the specified CoS value
before being presented to the system forwarding element. This selection requires
that the Mark CoS field be set.
• Send - These packets are presented unmodified by DiffServ to the system
forwarding element.
• Mark IP Precedence - These packets are marked by DiffServ with the specified IP
Precedence value before being presented to the system forwarding element. This
selection requires that the Mark IP Precedence field be set.
17. If you select Two Rate, you can configure additional fields (same fields as for a simple
policy).
18. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the nonconfigurable information displayed on the screen.
Configure the DiffServ Service Interface
 To configure the DiffServ service interface:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
Table 203. DiffServ Policy Configuration - Policy Attribute
Field Description
Policy Name Displays name of the DiffServ policy.
Policy Type Displays type of the policy as In.
Member Class Name Displays name of each class instance within the
policy.