User Manual

Multicast Routing
499
M6100, M5300, and M7100 Series Managed Switches
8. In the Go To Interface field, enter the interface in unit/slot/port format and click the Go
button.
The entry corresponding to the specified interface is selected.
9. Select the check box beside the Interface.
10. In the Admin Mode field, select Enable or Disable.
This sets the administrative status of MLD on the selected routing interface. The default is
Disable.
11. In the Version field, enter the version to configure for the selected interface.
Valid values are 1 to 2. The default value is 2.
12. In the Query Interval field, enter the frequency in seconds at which MLD host-query packets
are to be transmitted on this interface.
Valid values are 1 to 3600. The default value is 125.
13. In the Query Max Response Time field, enter the maximum query response time, in
milliseconds, to be advertised in MLDv2 queries on this interface.
Valid values are 0 to 65535. The default value is 10000 milliseconds.
14. In the Startup Query Interval field, enter the configured interval in seconds between
general queries sent by a querier on startup.
The default value is 31.
15. Enter the Startup Query Count value to indicate the configured number of queries sent out
on startup, separated by the startup query interval.
The default value is 2.
16. In the Last Member Query Interval field, enter the last member query interval in
milliseconds.
This is the maximum response time to be inserted into group-specific queries sent in
response to leave group messages, and is also the amount of time between
group-specific query messages. Valid values are from 0 to 655355. The default value is
1000 milliseconds.
17. In the Last Member Query Count field, enter the number of queries to be sent on receiving
a leave group report.
Valid values are from 1 to 20. The default value is 2.
18. Click the Apply button.