User Manual

Multicast Routing
492
M6100, M5300, and M7100 Series Managed Switches
7. Select Routing> IPv6 Multicast > IPv6 PIM > Interface Configuration.
8. In the Go To Interface field, enter the interface in unit/slot/port format and click the Go
button.
The entry corresponding to the specified interface is selected.
9. Select the check box beside the Interface.
10. In the Admin Mode field, select Enable or Disable.
This sets the administrative status of PIM-SM in the router. The default is Disable.
11. In the Hello Interval field, enter the time in seconds between the transmission of PIM hello
messages on this interface.
The valid values are from 0 to 18000. The default value is 30.
12. In the Join/Prune Interval field, enter the frequency at which PIM Join/Prune messages are
transmitted on this PIM interface.
The valid values are from 0 to 18000. The default value is 60.
13. In the BSR Border field, select the Enable or Disable option to set the bootstrap router
(BSR) border status on the selected interface.
14. Enter the DR Priority for the selected interface.
The valid values are from 0 to 2147483647. The default value is 1.
15. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the nonconfigurable data that is displayed.
Table 188. IPv6 PIM Interface Configuration
Field Description
Protocol State The state of PIM in the router. either Operational or Non-Operational.
IPv6 Prefix/Length The IPv6 address prefix and the length of the selected interface.
Designated Router The designated router on the selected PIM interface.
Neighbor Count The number of PIM neighbors on the selected interface.