User Manual

Configure System Information
35
M6100, M5300, and M7100 Series Managed Switches
Boot Version The version of the boot code that is in the flash memory to load the
firmware into the memory.
CPLD Version The version of the software for CPLD.
Serial Number The serial number of this switch.
Internal AC-1, Internal AC-2, and
so on
Indicates the status of the appropriate power module in each unit.
Status can be any of the following:
• Operational. Power module is present and functioning properly.
• Powering. Main power is failed or disconnected but RPS provides
power to the switch.
• Not Present. Power module is not present in the slot.
• Not powered. Power module is present but not connected to the
power source.
• Not powering. Power module is present and connected but the
switch uses another power source.
• Incompatible. Power module is present but incompatible.
• Failed. Power module is present, but power cable is not plugged in
or a bad cable is plugged in.
EPS Power Modules Indicates the status of the appropriate power module in each unit.
Status can be any of the following:
• Operational. Power module is present and functioning properly.
• Powering. Main power is failed or disconnected but RPS provides
power to the switch.
• Not Present. Power module is not present in the slot.
• Not powered. Power module is present but not connected to the
power source.
• Not powering. Power module is present and connected but the
switch uses another power source.
• Incompatible. Power module is present but incompatible.
• Failed. Power module is present, but power cable is not plugged in
or a bad cable is plugged in.
PoE Version Version of the PoE controller FW image.
N/A indicates that the Poe is not supported by the unit.
MAX PoE Indicates the status of maximum PoE power available on the switch as
follows:
• ON. Indicates less than 10W of PoE power available for another
device.
• OFF. Indicates at least 10W of PoE power available for another
device.
• N/A. Indicates that PoE is not supported by the unit.
Table 7. Device Status (continued)
Field Description