User Manual

Configure Switching Information
314
M6100, M5300, and M7100 Series Managed Switches
8. To configure one or more ports or LAGs, select the check box next to each port or LAG to
configure.
You can select multiple ports to apply the same settings to the selected interfaces.
9. In the MVRP Mode field, select Enable or Disable.
This specifies the administrative mode of Multiple VLAN Registration Protocol (MVRP) on
the interface. MVRP registers VLANs in the network, enabling automatic VLAN
configuration on the device.
10. In the MMRP Mode field, select Enable or Disable.
This specifies the administrative mode of Multiple MAC Registration Protocol (MMRP) on
the interface. MMRP allows the propagation of MAC address information in the network
and allows for the registration and deregistration of both individual MAC address
information and group MAC address membership.
11. Use the MRP Join Timer field to configure the amount of time in centiseconds to wait for
JoinIn messages from other MRV participants after the interface sends a Join message.
If the amount of time specified in this field passes before the interface receives a JoinIn
message, the interface resends the Join message. The range is 10 to 100 centiseconds.
The default value is 20.
12. Use the MRP Leave Timer field to configure the amount of time in centiseconds to wait
before the interface deregisters attributes from other MRV participants.
If the interface receives Join messages from other participants before the Leave timer
expires, the attributes are not deregistered. The range is 20 to 600 centiseconds. The
default value is 300.
13. Use the MRP Leave All Timer field to configure the amount of time to wait, after the
interface starts the MRP registration process, before the participants refresh and
reregister their attributes.
The range is 200 to 6000 centiseconds. The default value is 2000.
14. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.