User Manual

Configure System Information
30
M6100, M5300, and M7100 Series Managed Switches
By default VLAN 1 is used as the source interface.
9. Click the Apply button.
The updated configuration is sent to the switch and takes effect immediately. These
changes are not retained across a power cycle unless a save is performed.
The following table describes the status information the System Information screen displays.
Table 3. System Information
Field Description
Product Name The product name of this switch.
IPv4 Management VLAN Interface The IPv4 address and mask assigned to the management VLAN
interface.
IPv6 Management VLAN Interface The IPv6 prefix and prefix length assigned to the management VLAN
interface.
Management VLAN ID The management VLAN ID of the switch. Click the displayed
Management VLAN ID value to jump to the configuration screen.
IPv4 Service Port Network
Interface
The IPv4 address and mask assigned to the service port interface.
IPv6 Service Port Network
Interface
The IPv6 prefix and prefix length assigned to the service port interface.
IPv4 Loopback Interface The IPv4 address and mask assigned to the loopback interface.
IPv6 Loopback Interface The IPv6 prefix and prefix length assigned to the loopback interface.
System Date The current date.
System Up time The time in days, hours, and minutes since the last switch reboot.
Current SNTP Sync Status The current SNTP sync status.
System SNMP OID The base object ID for the switch's enterprise MIB.
System Mac Address Universally assigned network address.
Service Port MAC Address The MAC address used for out-of-band connectivity.
L2 MAC Address The MAC address used for communications on the Layer 2 network
segment.
L3 MAC Address The MAC address used for communications on the Layer 3 network
segment.
Supported Java Plugin Version The supported version of Java plug-in.
Current SNTP Synchronized Time The SNTP synchronized time.