User Manual

Configure System Information
29
M6100, M5300, and M7100 Series Managed Switches
7. Select System > Management > System Information.
8. Define the following fields:
• System Name. Enter the name to identify this switch. You can use up to 255
alphanumeric characters. The factory default is blank.
• System Location. Enter the location of this switch. You can use up to 255
alphanumeric characters. The factory default is blank.
• System Contact. Enter the contact person for this switch. You can use up to 255
alphanumeric characters. The factory default is blank.
• Login Timeout. Specify how many minutes of inactivity can occur on a serial port
connection before the switch closes the connection. Enter a number between 0 and
160 minutes. The factory default is 5. Entering 0 disables the time-out.
• Management Interface. Select the management interface that is used as source
interface for SNMP trap, syslog, DNS, TACACS+, RADIUS, sflow, and SNTP
applications. Possible values are as follows:
- Routing Interface
- Routing VLAN
- Routing Loopback Interface
- Service Port
- Different. For some application from the list, the source interface is configured
separately. They display in the list only if this is the case.