User Manual

Configure Switching Information
284
M6100, M5300, and M7100 Series Managed Switches
The web management interface menu displays.
7. Select Switching > Ports > Port Configuration.
8. Use Port to select the interface.
9. Use STP Mode to select the Spanning Tree Protocol administrative mode for the port or
LAG.
The possible values are as follows:
• Enable. Select this to enable the Spanning Tree Protocol for this port.
• Disable. Select this to disable the Spanning Tree Protocol for this port.
The default is Enable.
10. In the Admin Mode list, select Enable or Disable.
This sets the port control administrative mode.For the port to participate in the network,
you must select Enable. The factory default is Enable.
11. From the LACP Mode list, select Enable or Disable.
This selects the Link Aggregation Control Protocol administrative mode. The mode must
be enabled in order for the port to participate in link aggregation. The factory default is
Enable.
12. From the Auto-negotiation list, select Enable or Disable.
This specifies the auto-negotiation mode for this port. The default is Enable.
Note: After you change the auto-negotiation mode, the switch might be
inaccessible for a number of seconds while the new settings take
effect.
13. From the Speed list, select the speed value for the selected port.
Possible field values are as follows:
• Auto. All supported speeds.
• 100. 100 Mbits/second
• 10G. 10 Gbits/second.
The delimiter characters for setting different speed values are a comma (,), a period (.)
and a space ( ). For you to set the auto-negotiation speed, the auto-negotiation mode
must be set to Enable. The default is Auto.