User Manual

Configure Switching Information
248
M6100, M5300, and M7100 Series Managed Switches
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select Switching > STP > Advanced > PVST Interface.
8. Select a VLAN ID from the list of VLANs with enabled STP Admin mode and PVST or
RPVST.
Note: The Other option is used for configuring a VLAN which is not yet
created. Specify the required value for VLAN ID and click the Apply
button to observe actual values.
9. Configure the Priority value used to allow the operator to select the relative importance of
the port in the selection process for forwarding.
Set this value to a lower number to prefer a port for forwarding of frames. This priority
configuration is used when the port is configured as a point-to-point link type. The allowed
values are between 0 and 240. The priority values are listed in the following table. All
other values are rounded off. The default value is 128.
Note: The value must be a multiple of 16.T.
Table 94. PVST/RPVST Interface Configuration Priority Values
01632
48 64 80
96 112 128 (default)