User Manual

Chassis and Stacking
185
M6100, M5300, and M7100 Series Managed Switches
 To change the settings for an existing stack member:
1. Select the check box next to the stack member to configure.
2. If desired, specify a new unit ID for the stack member in the Change to Switch ID field.
The renumbering process causes the unit to reload.
3. Specify the switch type, priority, or management status from the available fields.
4. Click the Apply button.
The changes to the stack member are saved.
Note: If you configured a new unit number for an existing stack member, you
are asked to confirm the change. Click the OK button to continue or
click the Cancel button to retain the original settings.
5. Click the Delete button to remove the selected unit from the stack.
6. Click Refresh to update the screen with the latest information from the switch.
Note: In the case of adding or removing a dummy unit with POE for
preconfiguration, you must log in again to an actual web session to
apply changes and observe relevant POE web pages.
7. Click the Add button.
This adds the unit to the stack with the specific switch type.
8. To remove the selected unit from the stack, click the Delete button.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
To refresh the screen with the latest information on the switch, click the Update button.
The following table describes the nonconfigurable Stack Configuration fields.
Table 71. Stack Configuration
Field Description
Hardware Management
Preference
The hardware management preference of the switch. The hardware
management preference can be disabled or unassigned.