User Manual

Configure System Information
118
M6100, M5300, and M7100 Series Managed Switches
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select System > PoE > Advanced > PoE Port Configuration.
8. Select the Admin mode (Enable or Disable) to determine the ability of the port to deliver
power.
9. Port Priority is used to determine which ports can deliver power when the total power
delivered by the system crosses a specific threshold.
If the switch cannot supply power to all connected devices, the priority determines which
ports can supply power. The lowest numbered ports with the same Port Priority setting
are given higher priority. Select the priority order from the following list:
• Low. Low priority
• Medium. Medium priority
• High. High priority
• Critical. Critical priority
10. Select the High Power mode from the following options:
• Disabled indicates that a port is powered in the IEEE 802.3af mode.
• Legacy indicates that a port is powered using high-inrush current, used by legacy
PD's whose power requirements are more than 15W from power up.
• Pre-802.3at indicates a port is powered in the IEEE 802.3af mode initially and then
switched to the high-power IEEE 802.3at mode before 75 msec. This mode must be
selected if the PD is NOT performing Layer 2 Classification or the PSE is performing
2-Event Layer 1 Classification.
• 802.3at indicates that a port is powered in the IEEE 802.3at mode. For example, if the
class detected by PSE is not class4, then the PSE port does not power up the PD.
11. The Power Limit Type describes or controls the maximum power that a port can deliver.
Select the type from the following list:
• Class indicates that the port power limit is equal to the class of the PD attached.