User Manual

Configure System Information
115
M6100, M5300, and M7100 Series Managed Switches
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select System > PoE > Basic > PoE Configuration.
The Unit Selection field displays the current PoE unit.
8. To change the PoE unit, select another unit from the list.
9. To set the System Usage Threshold, enter a number from 1 to 99.
This sets the threshold level at which a trap is sent if consumed power is greater than the
threshold power.
10. The Power Management mode describes or controls the power management algorithm
used by the PSE to deliver power to the requesting PDs.
Select Static to indicate that the power allocated for each port depends on the type of
power threshold configured on the port. Select Dynamic to indicate that the power
consumption on each port is measured and calculated in real-time.
11. To set the traps, select Enable to activate the PoE traps.
Select Disable to deactivate the PoE traps. The default setting is enabled.
12. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the PoE Configuration nonconfigurable fields.
Table 40. PoE Configuration nonconfigurable Fields
Field Description
Units The Current PoE Unit. You can change the PoE Unit by selecting
another unit ID listed here.
Firmware Version Version of the PoE controller's FW image.
Power Status Indicates the power status.