User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Monitor the Switch and Network User Manual666
• Routing loopback interface
• T
unnel interface
• Service port
By default, VLAN 1 is used as the source interface.
6. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information.
Configure an sFlow Receiver
Use the sFlow Receiver Configuration page to configure the sFlow Receiver.
To configure an sFlow receiver:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Monitoring> sFlow >
Advanced > sFlow Receiver Configuration.
Table 229. sFlow Advanced Agent Information
Field Description
Agent Version Uniquely identifies the version and implementation of this MIB. The version
string must use the following structure: MIB V
ersion;Organization;Software
Revision where:
• MIB V
ersion: '1.3', the version of this MIB
• Organization: NETGEAR, Inc.
• Revision: 1.0
Agent Address The IP address associated with this agent.