User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Maintenance and Troubleshooting User Manual687
8. Enter the Datagram Size of ping packet.
The default value is 0 bytes. The range is 0 to 65507.
9. Enter the Source IP address or interface to use when sending the echo request packets.
If source is not required, select None as the source option. Possible values are as
follows:
• None.
The source address of the ping packet would be the address of the default
outgoing interface.
• IP Address.
The source IP address to use when sending the echo request packets.
This field is shown when IP Address is selected as the source option.
• Interface.
The interface to use when sending the echo request packets. This field is
shown when Interface is selected as the source option.
Note: Values configured in the fields on this page are not saved to the switch.
As a result, refreshing the page sets these fields to the default values.
10. Click the Apply button.
The pings are sent to the specified address. The switch sends the number of pings
specified in the Count field, and the results are displayed below the configurable data in
the Results area.
Ping an IPv6 Address
This page is used to send a ping request to a specified host name or IPv6 address. You can
use this to check whether the switch can communicate with a particular IPv6 station. When
you click the Apply button, the switch sends a specified number of ping requests and the
results are displayed below the configurable data. The output displays the following:
Send count=n, Receive count=n from (IPv6 Address). Average round trip
time = n ms.
To use Ping IPv6:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Maintenance > T
roubleshooting > Ping IPv6.