User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Switching Information User Manual256
Configure MLD Snooping for VLANs Manually
You can manually configure the settings for MLD snooping for VLANs, which is used to build
forwarding lists for multicast traffic. You can also configure MLD snooping for VLANS
automatically (see
Configure MLD Snooping for VLANs Automatically with MLD Plus Mode
on page 254).
To configure the settings for MLD snooping for VLANs manually:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Switching> Multicast > MLD Snooping > MLD VLAN Configuration.
5. Select the check box for the VLAN ID for which MLD snooping must be enabled.
6. From the Fast Leave menu, select to enable or disable the MLD snooping Fast Leave Mode
for the specified VLAN ID.
7. In the Membership Interval field, specify the value for the group membership interval of
MLD snooping for the specified VLAN ID.
The valid range is (Maximum Response Time + 1) to 3600.
8. In the Maximum Response T
ime field, specify the value for the maximum response time of
MLD snooping for the specified VLAN ID.
The valid range is 1 to (Group Membership Interval –1). Its value must be less than group
membership interval value.