User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure Multicast Routing User Manual456
Configure the IPv6 PIM Candidate Rendezvous Point
To configure the IPv6 PIM candidate rendezvous point:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing> IPv6 Multicast > IPv6 PIM > Candidate RP Configuration.
5. From the list of interfaces, select the Interface.
6. In the Group Address field, enter the group IPv6 address prefix transmitted in
candidate-RP-advertisements.
7. In the Prefix Length field, enter the group IPv6 Prefix Length transmitted in
candidate-RP-advertisements
8. In the C-RP Advertisement
Interval, specify the duration in seconds at which the C-RP
messages are unicast to the bootstrap router (BSR).
The range is from 1 to 16383 seconds. The default value is 60 seconds. If this field is
submitted without any value, the default value is used.
9. Click the Add button.
The candidate-RP address is added for the PIM router.
Up Time (hh:mm:ss) The time since this PIM neighbor (last) became a neighbor of the local
router.
Expiry Time (hh:mm:ss) The minimum time remaining before this PIM neighbor is aged out.
Table 174. IPv6 PIM Neighbor
Field Description