User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure OSPF and OSPFv3 User Manual370
3. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Routing > OSPF >
Advanced > Area Range Configuration.
5. Enter the OSPF Area ID.
An area ID is a 32-bit integer in dotted-decimal format that uniquely identifies the area to
which a router interface connects.
6. Enter the IP Address for the address range for the selected area.
7. Enter the Subnet Mask for the address range for the selected area.
8. From the list in the LSDB T
ype field, select the type of link advertisement associated with
the specified area and address range.
Options are as follows: Network Summary or NSSA External.
The default type is
Network Summary.
9. In the Advertise list, select Enable or Disable.
If you select Enable, the address range is advertised outside the area through a network
summary LSA.
The default is Enable.
10. Click the Add button.
The new address range is added.
11. Click the Apply button.
Your settings are saved.
Configure the OSPF Interface
To configure the OSPF interface:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.