User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual133
This enables or disables activation of authentication failure traps. The factory default is
Enable.
6. Select the Link Up/Down Disable or Enable radio button
This enables or disables activation of link status traps.The factory default is Enable.
7. Select the Multiple Users Disable or Enable radio button
This enables or disables activation of multiple user traps.The factory default is Enable.
This trap is triggered when the same user ID is logged into the switch more than once at
the same time (either through
Telnet or the serial port).
8. Select the Spanning T
ree Disable or Enable radio button.
This enables or disables activation of spanning tree traps. The factory default is Enable.
9. Select the ACL Disable or Enable radio button.
This enables or disables activation of ACL traps. The factory default is Disable.
10. Select the PoE Disable or Enable radio button.
This enables or disables activation of PoE traps. The factory default is Enable. Indicates
whether PoE traps are sent.
11. Click the Apply button.
Your settings are saved.
View the Supported MIBs
To view all the MIBs supported by the switch:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > SNMP > SNMP V1/V2 >Supported MIBs.