User Manual

Table 171. Trap log information (Continued)
DescriptionField
The number of traps that occurred since the traps were last displayed.
Note: If you save the trap log to another device (that is, you upload the file
from the switch), this counter is set to 0.
Number of Traps since log
last viewed
The sequence number of this trap.Log
The time when this trap occurred, expressed in days, hours, minutes and
seconds, since the last reboot of the switch.
System Up Time
Information about the trap.Trap
Event log
You can display and clear the event log, which contains error messages from the switch.
Note: If you reset the switch to factory default settings, the event log is not cleared.
To display or clear the event log:
1. Launch a web browser.
2.
In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Monitoring > Logs > Event Logs.
The Event Logs page displays.
6.
To refresh the page, click the Refresh button
7. To clear the log, click the Clear button.
8.
To save the settings to the running configuration, click the Save icon.
Main User Manual717Monitor the Switch and Network
AV Line of Fully Managed Switches M4250 Series Main User Manual