User Manual

To add or remove an IPv6 default route address for the IPv6 management interface:
1. Launch a web browser.
2.
In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5.
Select System > Management > Management Interfaces > IPv6 Management
Interface Configuration.
The IPv6 Management Interface Configuration page displays.
6.
To add an IPv6 default route address, in the IPv6 Default Route Configuration section,
do the following:
a.
Select the Change IPv6 Default Route check box.
b.
In the IPv6 Default Route Address field, specify the IPv6 address and prefix
length that you want to add.
c. Click the Add button.
The IPv6 default route address is added to the IPv6 management interface.
7.
To remove an IPv6 default route address, in the IPv6 Default Route Configuration
section, do the following:
a.
Select the check box for the IPv6 default route address that you want to remove.
b. Click the Delete button.
The IPv6 default route address is removed from the IPv6 management interface.
8.
To save the settings to the running configuration, click the Save icon.
Time and SNTP settings
The switch supports the Simple Network Time Protocol (SNTP). As its name suggests,
it is a less complicated version of Network Time Protocol (NTP), which is a system for
Main User Manual66Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual