User Manual

The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5.
Select System > Management > Management Interfaces > IPv6 Management
VLAN Configuration.
The IPv6 Management VLAN Configuration page displays.
6.
In the Management VLAN ID field, specify the management VLAN ID of the switch.
The IPv6 management VLAN is used for management of the switch. You can configure
any value in the range of 1 to 4093.
7.
Select the IPv6 Enable Mode Enable or Disable radio button to specify he
administration mode for the IPv6 management VLAN.
8.
Select the Address Autoconfigure Mode Enable or Disable radio button to specify
the address autoconfiguration mode.
If you enable this mode, the IPv6 network settings (IPv6 prefix and prefix length) are
automatically configured for the configured management VLAN interface. By default,
for VLAN 1, the mode is enabled so that the settings are automatically configured.
Note: The Address Autoconfigure mode option is available only if unicast routing
is globally disabled.
9.
Select the Address DHCP Mode Enable or Disable radio button to specify if the
IPv6 settings are obtained from a DHCP server.
10. Click the Apply button.
Your settings are saved.
11.
To save the settings to the running configuration, click the Save icon.
Note: If you need to reset the IPv6 management interface, in the Reset IPv6 Management
Interface section of the page, select the Set Management Interface to Default check
box and click the Apply button. Doing so deletes the IPv6 management interface
configuration.
The Current IPv6 Management Interface Status section displays the following
nonconfigurable fields.
Main User Manual59Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual