User Manual

•
Subnet Mask: Specify the subnet mask for the management interface.
The default subnet mask is 255.255.0.0.
•
Gateway: Specify the IP address of the default gateway for the management
interface.
The default IP address is 0.0.0.0.
9. Click the Apply button.
Your settings are saved.
10.
To save the settings to the running configuration, click the Save icon.
Note: If you need to reset the IPv4 management interface, in the Reset IPv4 Management
Interface section of the page, select the Set Management Interface to Default check box
and click the Apply button. Doing so deletes the IPv4 management interface
configuration and sets the IPv4 management interface back to the default setting.
The Current IPv4 Management Interface section displays the following nonconfigurable
fields.
Table 13. Nonconfigurable IPv4 management interface status information
DescriptionField
Displays the current IPv4 management interfaceManagement Interface
Indicates whether the link status is up or down.Link State
Indicates whether the link status is up or down for the management
interface.
Routing Interface Status
The MAC address assigned to the management interface.MAC Address
Indicates whether the IP address configuration method is DHCP or manual.IP Address Configuration Method
The IP address of the management interface.IP Address
Main User Manual54Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual