User Manual

Table 138. Service Interface Configuration information
DescriptionField
The traffic direction (In, Out, or both In and Out) of the policy or policies on the service
interface.
Direction
The operational status of this service interface (either Up or Down).
The operational status is shown as Up if all of the following conditions are true:
•
The attached class is valid and includes at least one matching rule.
•
The attached policy is valid and includes at least one attribute.
•
The port is enabled, that is, the physical link of the port is in the up state.
Operational Status
Change one or both DiffServ policies for an interface To change one or
both DiffServ policies for an interface:
1. Launch a web browser.
2.
In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5.
Select QoS > DiffServ > Advanced > Service Interface Configuration.
The Service Interface Configuration page displays.
6.
Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
•
1 (the unit ID of the switch): Only physical interfaces are displayed. This is the
default setting.
• LAG: Only LAGs are displayed.
•
All: Both physical interfaces and LAGs are displayed.
7.
Select the check box for the interface.
8.
To select another inbound policy, from the Policy In Name menu, select another
policy name.
Main User Manual490Configure Quality of Service
AV Line of Fully Managed Switches M4250 Series Main User Manual