User Manual

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5.
Select QoS > DiffServ > Advanced > Service Interface Configuration.
The Service Interface Configuration page displays.
6.
Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
•
1 (the unit ID of the switch): Only physical interfaces are displayed. This is the
default setting.
• LAG: Only LAGs are displayed.
•
All: Both physical interfaces and LAGs are displayed.
7.
Select one or more interfaces by taking one of the following actions:
•
To configure a single interface, select the check box associated with the port, or
type the port number in the Go To Interface field and click the Go button.
•
To configure multiple interfaces with the same settings, select the check box
associated with each interface.
•
To configure all interfaces with the same settings, select the check box in the
heading row.
8.
From the Policy In Name menu, select the name of a policy for inbound traffic.
9.
From the Policy Out Name menu, select the name of a policy for outbound traffic.
10. Click the Apply button.
Your settings are saved.
11.
To save the settings to the running configuration, click the Save icon.
The following table describes the nonconfigurable fields on the page.
Main User Manual489Configure Quality of Service
AV Line of Fully Managed Switches M4250 Series Main User Manual