User Manual

The policy name is a hyperlink to the page on which you can define the policy
attributes (see the following figure, which does not show the Two Rate section of
the page).
11.
Configure the policy attributes by selecting one of the following radio buttons:
•
Assign Queue: Select this radio button to specify that traffic must be assigned to
a queue, which you must select from the menu. The queue is expressed as a value
in the range from 0 to 7.
• Drop: Select this radio button to require each packet to be dropped.
•
Mark VLAN CoS: Select this radio button to specify the VLAN priority, which you
must select from the menu. The VLAN priority is expressed as a value in the range
from 0 to 7.
• Mark IP Precedence: Select this radio button to require packets to be marked
with an IP precedence value before being forwarded. You must select an IP
precedence value from 0 to 7 from the menu.
•
Mirror: Select this radio button to require packets to be mirrored to an interface
or LAG, one of which you must select from the menu.
• Redirect: Select this radio button to require packets to be redirected to an
interface or LAG, one of which you must select from the menu.
Main User Manual481Configure Quality of Service
AV Line of Fully Managed Switches M4250 Series Main User Manual