User Manual

If GVMP is enabled, the switch can share multicast information with devices in the
network. the The default is Disable.
8. Click the Apply button.
Your settings are saved.
It can take up to 10 seconds for GARP configuration changes to take effect.
9.
To save the settings to the running configuration, click the Save icon.
Configure GARP settings for one or more interfaces You can configure
GARP settings for individual interfaces. These settings take effect only if GVRP mode,
GMRP mode, or both modes are enabled on the switch.
To configure GARP settings for one or more interfaces:
1. Launch a web browser.
2.
In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5.
Select Switching > VLAN > Advanced > GARP Port Configuration. The
The GARP Port Configuration page display.
6.
Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
•
1: Only physical interfaces are displayed. This is the default setting.
• LAG: Only LAGs are displayed.
•
All: Both physical interfaces and LAGs are displayed.
7.
Select one or more interfaces by taking one of the following actions:
•
To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
•
To configure multiple interfaces with the same settings, select the check box
associated with each interface.
Main User Manual217Configure Switching Information
AV Line of Fully Managed Switches M4250 Series Main User Manual