User Manual

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5.
Select System > LLDP > LLDP-MED > Interface Configuration.
The Interface Configuration page displays.
6.
Select one or more interfaces by taking one of the following actions:
•
To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
•
To configure multiple interfaces with the same settings, select the check box
associated with each interface.
•
To configure all interfaces with the same settings, select the check box in the
heading row.
The following two fields are nonconfigurable on the page:
•
The Link Status fields shows whether the interface is up or down.
•
The Operational Status field shows whether LLDP-MED TLVs are transferred on
this interface.
7.
From the MED Status menu, select if LLDP-MED mode is enabled or disabled on
the interface.
The default is Enable.
8.
From the Receive menu, select if the interface can receive LLDP notifications.
The default is Enable.
9.
From the Notification Status menu, select if the interface can support LLDP-MED
notifications.
The default is Disable.
10.
Configure if the following transmit Type Length Value (TLV) information, all of which
is enabled by default, is transmitted for LLDP-MED in LLDP PDU frames:
•
MED Capabilities. Select if the interface can send the MED capabilities in an LLDP
frame.
•
Network Policy: Select if the interface can send the network policy in an LLDP
frame.
•
Location Identification: Select if the interface can send location information in
an LLDP frame.
•
Extended MDI-PSE: Select if the interface can send power sourcing equipment
(PSE) information in an LLDP frame.
Main User Manual172Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual