User Manual

We recommend these port connections for the one-touch performance presets (see Apply a Performance
Preset Mode on page 25). However, you can save custom performance presets and use different port
connections (see Manage Custom Performance Preset Modes on page 28).
• DC power connector. One 12V, 1.0 A DC connector for the power adapter.
The RESET button is located on the bottom panel of the switch. Press the RESET
button for five seconds to reset the switch to factory default settings. For more
information, see Return the Switch to Its Factory Default Settings on page 74.
Note
Switch Label
The switch label on the bottom panel of the switch shows the serial number, MAC address, and default login
information of the switch.
Figure 4. Switch label
Safety Instructions and Warnings
Use the following safety guidelines to ensure your own personal safety and to help protect your system from
potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment, observe the following
precautions:
• This product is designed for indoor use only in a temperature-controlled (32–104°F or 0–40°C) and
humidity-controlled (90 percent maximum relative humidity, noncondensing) environment.
Any device that is located outdoors and connected to this product must be properly grounded and surge
protected.
To the extent permissible by applicable law, failure to follow these guidelines can result in damage to
your NETGEAR product, which might not be covered by NETGEAR’s warranty.
• Observe and follow service markings:
Hardware Overview of the Switch
10
Nighthawk S8000 Gaming & Streaming Advanced 8-Port Gigabit Ethernet Switch (GS808E)